I dont find relevant documentation about how configure step by step smart config using at commands.
I am using a external microcontroller to communicate with ESP8266 (esp01 module).
I am using pure C Programming in microcontroller( No arduino hardware and no arduino Library ).
In the moment i connect with router through AT+CWJAP and all has OK.
The ssid and password are hardcoded in flash of my microcontroller.
I can configure the connection with the router dynamically through smart config( AT+CWSTARTSMART ) because the equipament can change of place and router.
There is some examples or a step by step example ?
I already read the document: 30b-esp-touch_user_guide_en_v1.1_20160412_0.pdf.
Who is online
Users browsing this forum: No registered users and 3 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!