ESP烧写bin文件后,不能使用AT指令
ESP烧写bin文件后,不能使用AT指令
Postby james » Wed Jul 15, 2015 11:26 am
使用过程中,参照esp_iot_sdk_v1.2.0_15_07_03中的位于 \esp_iot_sdk\bin\at目录下的readme.txt说明 ,烧录eagle.flash.bin(addr:0x00000),eagle.irom0text.bin(addr:0x40000),blank.bin(addr:0x3e000)到相应的地址,FLASH SIZE选择4Mbit,选择相应的COM口,波特率设置为115200,最后显示烧录完成。最后在利用SecureCRT工具时候,设置波特率74880以及115200都实验过,发现在SecureCRT不能正常的输入字符串,无法正确的使用ESP-WROM模组,其工作时候相应电流为28mA,然后我们更换使用sscom42.exe这一款串口的时候,发现发送“AT+CWMODE=3”,串口工具上没有出现“ok”,麻烦请问一下这会是什么原因导致出现以上的问题?
Re: ESP烧写bin文件后,不能使用AT指令
Postby ESP_Faye » Wed Jul 15, 2015 11:58 am
您好,
建议您将有关 AT 指令的问题发布在 AT+command 版块 http://bbs.espressif.com/viewforum.php?f=16
AT 指令以换行符结尾,请注意您的串口工具是否做了相关设置
工具 SecureCRT 的设置请参考 \esp_iot_sdk_v1.2.0\document\CN 路径下文档“4B-ESP8266__AT Command Examples”的 “ 1. 前言 ”
工具 sscom42.exe 请勾选 “发送新行”
感谢您对 ESP8266 的关注 !
建议您将有关 AT 指令的问题发布在 AT+command 版块 http://bbs.espressif.com/viewforum.php?f=16
AT 指令以换行符结尾,请注意您的串口工具是否做了相关设置
工具 SecureCRT 的设置请参考 \esp_iot_sdk_v1.2.0\document\CN 路径下文档“4B-ESP8266__AT Command Examples”的 “ 1. 前言 ”
工具 sscom42.exe 请勾选 “发送新行”
感谢您对 ESP8266 的关注 !
Who is online
Users browsing this forum: No registered users and 0 guests
Login
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
Latest SDK
Documentation
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!
- All times are UTC+08:00
- Top
- Delete all board cookies
About Us
Espressif Systems is a fabless semiconductor company providing cutting-edge low power WiFi SoCs and wireless solutions for wireless communications and Internet of Things applications. We are the manufacturer of ESP8266EX.